Aeotec Home Energy Meter Gen5, Z-Wave Plus Smart Electricity Usage Monitor, Report Real Time Power Consumption, 1 Clamp, Detect up to 60 amps for Single Phase System

Product Information

This product works very well with the Tuya Smart app, with accurate real-time display of power consumption. Individually monitor the consumption of any of your home appliances, electric circuits and office equipment (lights, sockets, security systems, heating and cooling, etc. After seeing the introduction of the Energy section in Home Assistant, I wanted to get onboard with monitoring the homes electricity consumption. I found that I needed to calibrate the bottom end of the sensor slightly too because it was picking up some interference and reporting about 60 amps when nothing was connected, so my lower end calibration value is actually 0. You should still have your own consumer unit or 'fuse box', you can clamp it around the incoming supply to that to get a reading for your whole installation.

Back over in the configuration we un-comment the calibrate-linear section and make sure that line 58 says that at 0.Embrace Elegance: Explore the beauty of creating sophisticated smart setups that prioritize simplicity, ensuring daily operations are a breeze for all.

At the time of writing, Aeotec do not offer any HEM units that are compatible with Aussie standards. Then it is worthless to me as I live in a block of flats and the electricity meter is in a special locked room under the stairs at ground floor. Installed in an electricity box, the energy meter will monitor the total consumption of electricity used by an entire building. Z-Wave Plus Aeotec Clamp Power Meter - Three Clamps (60A) includes the following technologies, which means it should work fine with other devices using the same technology. I do not have the device to test this (I gifted it in a reddit giveaway), but please add this to your Zigbee2MQTT configuration.Shelly EM can connect directly to any Wi-Fi network, no HUB required or can operate as an Access Point. The best way to calibrate it is to attach the clamp around a cable with a known current running through it. It detects the energy flows of the PV system and transmits the excess energy data to the PV Power Manager AC•THOR, AC•THOR 9s. I filter lines printed on the serial line whose first word is “OK” and use simple shell arithmetics to post data using a Zabbix utility.